Product Specifications

--

Product Description

10A 12V/24V Solar Street Light Charge Controller 15hours Timer 10I-St

10I-ST-10A / 20I-ST-20A

Specification

Main Features

Application Method

Solar Home System           Solar Street Light System 

Attention

Connection Order:Connect the battery with the controller.

Connect the solar panel with the controller.

Connect the load with the controller or inverter.

Disconnection order:

Disconnect the solar panel.

Disconnect the battery.

Disconnect the load.

Precautions:

please make sure connect your inverter with your battery

Please avoid to install in the following environments wet,dusty places or places with flammable and explosive gases.

Install the controller at the vertical plane.

General  Pakage

Instructions

Protection:

Overcharging protection

Can be used for all panels

Overdischarging protection

Short and Open Circuit protection

Full specification available if required

Fail Safe and cannot be damaged by accidental wiring mistakes

Advanced design with simple plug and play technology. No need for complicated adjustments

Full LED status indication: State of Charge(SOC) Red-Flat Battery: Amber-Low charge: Green- good charge: Green Flashing- Full Charge

Features:

Microcontroller digital accuracy

PWM charge mode & State of Charge(SOC)

Fully automatic operation & Electronic protections

Detects day and night using the PV array, timer setting

Double digital LED display, numbers equal to timer setting

Temperature compensation, with inside temperature sensor

Big terminals, big distance between terminals

Rating:

20I: 12 Volt or 12/24 Volt auto work, 20 Amps (for PV and load)

Equalisation voltage: 14.8Volt

High voltage disconnect(HVD): 14.4Volt

Float voltage: 13.6Volt

Low voltage disconnect(LVD) 11.1Volt

Low voltage reconnect(LVR): 12.6Volt

Self-consumption: 6mA maximum

Temperature compensation: -30mV/C/12V

Terminals: for wire sizes to 6mm2

Temperature: -35C to +55C

LED indicator:

Solar Panel LED:

Green ON when solar is charging Battery.

Green blink when the syetem over voltage

Battery LED:

Green ON when battery level in the right range

Green Slowly flashing when battery level full

Yellow ON when battery level low

RED ON when loads cut off.

LOAD LED:

RED ON when the output is on

RED slowly flashing when it`s over load

(the load amps is 1.24 times of rated current for 60 seconds,or the load amps is 1.5 times of rated current for 5 seconds.)

RED blink when the load is short -circuit.

This controller has Light and Timer control Function

Light control:When daylight starts to occur then the light source goes off. Meanwhile the Solar Panels will charge the batteries. when there is no sunlight the garden light will switch on.

Time control:There is an eight hours time control,that means it will go off when the Lights automatically switch off after 0-15 hours.

Lighting control Option

1.Press the power switch for 5 seconds and select the desired LIGHTING CONTROL option.The LED is on,which confirmed you have selected the right one.

2.The controller requires 10 munites of countinuous transiton values before it starts to work.These constraints avoid false transitions due to lighting or dark storm clouds.

3.10 minutes off before the controller start to work

4.A brief description follows belows:

Supply Ability

--

Packaging and Shipping

Lead time

--

Port

--

Packaging details

--